Billi Installation – Filtered Drinking Water Systems

Benchtop Limitations:

Standard Installation DOES NOT include installations on granite or natural stone bench tops nor bench tops that are greater than 48mm in thickness.

Font installation is not considered to be part of a Standard Installation and is therefore not included in this offer.

If extra parts such as extension kits or replacement valves or connections are required during the installation, this will be at the discretion and additional cost of the customer.

Electrical and Plumbing Requirements:

Sufficient power and plumbing supply must already be in place prior to Installation. Any additional electrical or plumbing requirements outside the standard requirements for a Billi unit will be at the customer’s expense. Power and water must be ready for connection at final install location. Please refer to product install guide for further information.

Failure to prepare the site for the agreed date will incur a standard callout fee for any and each re-attend(s) required.

Installation Plumbing Requirements for Billi’s Multifunction Mixer Tap

For the installation of your Billi Multifunction Mixer Tap, please note the following:

• A domestic Cold and Hot mains supply via separate ½” BSP (15mm) isolation valves must be pre-installed in an easily accessible position.
• The under-bench system requires an additional Cold mains supply ½” BSP (15mm) isolation valves, bringing the total to three isolation valves.
• All isolation valves must be pre-installed by a licensed plumber before a Billi technician can be booked to install and commission your new Billi unit.

Billi recommends the underbench system to be installed with it’s own isolation valve, however this may not be required in all cases.  This should be discussed with your qualified installer.

Locations:

The standard Installation delivery area is limited to 50KM from metro areas of Melbourne, Sydney, Brisbane, Canberra, Darwin, Perth, Adelaide & Hobart.